Picture below is front panel BlueCoat PacketShaper 1700
To setup IP address BlueCoat PacketShaper 1700 using CLI, first we must connect to console.
You could connect it using USB to serial cable and console cable like the picture below.
To setup IP address BlueCoat PacketShaper 1700 using CLI, first we must connect to console.
You could connect it using USB to serial cable and console cable like the picture below.
Then use your favorite application to connect to serial port / console.
I am using SecureCRT.
To configure IP address, type:
# setup ipaddress <addr> <netmask>
example:
# setup ipaddress 192.168.0.1 255.255.255.0
After you setup ip address you could log in to web configuration.
Type: http://192.168.0.1/
on your browser.
ReplyDeletenice blog take a look.
CISCO Certified Partner
A great content material as well as great layout. Your website deserves all of the positive feedback it’s been getting. I will be back soon for further quality contents. IP Address
ReplyDeletenice
ReplyDeleteCISCO Certified Partner
Fortinet Certified Partner
Certified Paloalto Partner
IPv4, which depends on a solitary 32-piece number that underpins preferably less over 2^32 (4 billion) extraordinary locations. This rendition is utilized generally right now. Given that each PC, worker, switch and so forth on the Internet needs an extraordinary location, we are quickly coming up short on addresses.
ReplyDeletejiofi.local.html
I really appreciate this wonderful post that you have provided for us. I assure this would be beneficial for most of the people.192.168.1.254
ReplyDelete